BPG is committed to discovery and dissemination of knowledge
Cited by in F6Publishing
For: Shaikh MQ, Nath SD, Akilan AA, Khanjar S, Balla VK, Grant GT, Atre SV. Investigation of Patient-Specific Maxillofacial Implant Prototype Development by Metal Fused Filament Fabrication (MF3) of Ti-6Al-4V. Dent J (Basel) 2021;9:109. [PMID: 34677171 DOI: 10.3390/dj9100109] [Cited by in Crossref: 4] [Cited by in F6Publishing: 4] [Article Influence: 2.0] [Reference Citation Analysis]
Number Citing Articles
1 Denour E, Eyen SL. Emerging applications of 3D printed microporous prosthesis in nonunion repair: mechanisms and therapeutic potential. Ann Transl Med 2022;10:1299. [PMID: 36660651 DOI: 10.21037/atm-22-5436] [Reference Citation Analysis]
2 Arumugham Akilan A, Enneti RK, Balla VK, Atre SV. Effects of Hot Isostatic Pressing on the Properties of Laser-Powder Bed Fusion Fabricated Water Atomized 25Cr7Ni Stainless Steel. Lubricants 2022;10:340. [DOI: 10.3390/lubricants10120340] [Reference Citation Analysis]
3 Vyavahare S, Mahesh V, Mahesh V, Harursampath D. Additively Manufactured Meta-biomaterials: A State-of-the-Art Review. Composite Structures 2022. [DOI: 10.1016/j.compstruct.2022.116491] [Reference Citation Analysis]
4 Tosto C, Tirillò J, Sarasini F, Sergi C, Cicala G. Fused Deposition Modeling Parameter Optimization for Cost-Effective Metal Part Printing. Polymers 2022;14:3264. [DOI: 10.3390/polym14163264] [Cited by in Crossref: 2] [Cited by in F6Publishing: 3] [Article Influence: 2.0] [Reference Citation Analysis]
5 Kaczmarek K, Konieczny B, Siarkiewicz P, Leniart A, Lukomska-szymanska M, Skrzypek S, Lapinska B. Surface Characterization of Current Dental Ceramics Using Scanning Electron Microscopic and Atomic Force Microscopic Techniques. Coatings 2022;12:1122. [DOI: 10.3390/coatings12081122] [Reference Citation Analysis]
6 Czyżewski W, Jachimczyk J, Hoffman Z, Szymoniuk M, Litak J, Maciejewski M, Kura K, Rola R, Torres K. Low-Cost Cranioplasty—A Systematic Review of 3D Printing in Medicine. Materials 2022;15:4731. [DOI: 10.3390/ma15144731] [Reference Citation Analysis]
7 Shaikh MQ, Berfield TA, Atre SV. Residual stresses in additively manufactured parts: predictive simulation and experimental verification. RPJ 2022. [DOI: 10.1108/rpj-02-2022-0045] [Cited by in Crossref: 3] [Cited by in F6Publishing: 3] [Article Influence: 3.0] [Reference Citation Analysis]